Wilton End Caps

End Caps for Wilton Vises and Bullet Vises
 
Easily pressed in and removed with a 1/2" wooden dowel.
 
Built individually from steel and are not stamped out like the originals, so you will not have to worry about denting these. 
 
Note: Take a die grinder to the inside bore of the  End Cap area if there is a rough casting and several high spots. Lightly tap the end cap in, if it hesitates, remove it and polish out the high spots on the vise until it sits in the correct place. 
 
*Important* beating these on could cause the casting (your vise) to crack.  Your new End Cap will be fine though!!